Skip to content
Sign in
Guide

Moissanite vs diamond: what a camera can tell

Updated · By Larpea

On camera, viewers rarely tell moissanite from diamond: the difference is more coloured flash under a point of light. GIA lists moissanite at 2.648 and 2.691 refractive index and 9¼ hardness, against 2.42 and 10. This larp props guide compares them, plus cubic zirconia, and explains lighting.

Can viewers tell moissanite from diamond on camera?

On a phone, in a short video, almost never. A lens turns both into bright points, and the difference viewers could pick up is in the flash: moissanite throws more coloured fire than diamond, so under a hard point of light a moissanite chain can look busier. This page, part of our larp props and sets hub, puts the published numbers in a table, shows a fair way to light a chain, and says plainly why you should not pass moissanite off as diamond.

The numbers below come from GIA, the Gemological Institute of America, and not from us.

The numbers, from GIA

Four properties and one test, side by side. Cubic zirconia is included because it is the budget choice and the one most often confused with the other two.

Checked on .

Diamond, moissanite and cubic zirconia, properties as published by GIA
PropertyDiamondMoissaniteCubic zirconiaSources
Refractive index2.422.648 and 2.691: two values, because moissanite is doubly refractiveNot stated on the GIA page we readGIA, natural diamond; Gems & Gemology, Winter 1997
Dispersion (fire)Not stated on the GIA page we read0.104; GIA’s consumer guide says more than twice the fire of diamondSlightly more fire than diamond, with less brillianceGems & Gemology, Winter 1997; GIA, simulated diamonds
Mohs hardness109¼ (also written 9.25)8.5, so it scratches more easily than diamondGIA, natural diamond; GIA, simulated diamonds
Specific gravity3.52 (±0.01)3.22Not stated on the GIA page we readGIA, natural diamond; Gems & Gemology, Winter 1997
How to tell it from diamondSingly refractiveDoubly refractive: a doubling at facet junctions. A thermal probe reads it as diamondLess brilliance; scratches; colourless stones may yellow over timeGems & Gemology, Winter 1997; GIA, simulated diamonds

Two cells say “not stated on the GIA page we read”, and we leave them that way rather than fill them from memory. The numbers that matter for a lens are the middle ones: moissanite’s fire is higher, its hardness is a notch below diamond’s, and a basic thermal probe cannot separate it from diamond.

What fire does on camera

Fire is the flash of spectral colour inside a stone. A stone with a lot of it throws red, blue and orange sparks when light moves across it. On a phone sensor those sparks are small and fast, and they read as sparkle. Three things follow.

  • Soft light calms it. A window or a large softbox gives broad highlights and few sparks, so moissanite and a diamond look alike.
  • A point of light excites it. A phone torch or a bare bulb makes moissanite flash in colour. On a necklace in motion it looks like a disco ball.
  • Size amplifies it. GIA’s guide notes that extreme fire can make a large stone look artificial. A big, flat-set chain is where that shows.

Cubic zirconia has less brilliance than either, and it scratches easily, so after a few months of wear it can look cloudy in a close-up. That is the practical reason a CZ chain suits a first video and a moissanite chain suits a series.

A fair three-light test you can run yourself

If you want to see the difference for your own piece, test it under three lights in the same position, and compare the three frames side by side.

  1. Daylight by a window. The softest. Shoot the piece on a dark cloth, with the window to one side.
  2. A ring light. A ring light held close is the light most chain videos use.
  3. A single point of light. A phone torch from a metre away. This is where fire shows.

Keep the camera, the distance and the exposure identical, and move only the light. If two stones look the same in the first two frames and differ in the third, you have learned what your own lens can and cannot show. We have not published our own comparison photographs for this page yet; we would rather say so than show you pictures that are not ours.

Why a diamond tester will not settle it

People ask whether a moissanite chain “passes a diamond tester”. The honest answer is that a basic thermal probe reads moissanite as diamond, because the two conduct heat in a similar way. GIA’s 1997 paper on the synthetic stone says exactly that, and it describes the reliable separation: moissanite is doubly refractive, so a loupe shows a doubling at the facet junctions.

That fact has two uses and one abuse. It is why a thermal probe alone is not enough when you buy a stone sold as diamond. It is why a lab report from a gemmological laboratory is the thing to ask for. The abuse is selling moissanite as diamond, which is fraud, and it is the reason a listing, a caption and a box should all say “moissanite”. GIA’s own advice on telling the stones apart is to submit one to a laboratory for a report.

Which one for which video

The choice depends on how many videos the piece has to survive.

  • One skit, one budget. An iced cubic zirconia chain looks right at arm’s length and in a night-time phone shot. The finish fades with sweat over months.
  • A series, or close-ups. A moissanite chain set edge to edge holds up better: it is harder, and it throws more fire.
  • The detail shot. A bracelet or a pair of studs carries a hand or an ear in a close-up. The same logic applies.

A moissanite chain costs a multiple of a cubic zirconia one; the extra buys fire and hardness, not a different look at a distance. A piece you do not own is a prop, and a prop that says what it is is the honest version. For the other things that carry a flex frame, see car keys without the logo trouble and renting a luxury watch, and for the places to shoot them, a private jet set.

Questions

Can you tell moissanite from diamond on camera?
Rarely. A phone turns both into bright points. The tell is coloured fire: moissanite throws more of it, especially under a point of light, so it can look busier. Under soft window light the two look alike.
Does moissanite pass a diamond tester?
A basic thermal tester reads moissanite as diamond, so it cannot settle the question. Moissanite is doubly refractive, which a loupe can show as a doubling at the facet junctions, and a gemmological laboratory report settles it.
Is moissanite harder than cubic zirconia?
Yes. GIA gives moissanite a Mohs hardness of 9¼ and cubic zirconia 8.5, against 10 for diamond. Cubic zirconia scratches more easily and can cloud over months of wear.
Does a moissanite chain look real on video?
It reads as expensive ice from arm’s length, and in close-ups it throws a lot of fire. How it looks depends mostly on the light: soft light calms it and a point of light excites it.
Can I call a moissanite chain a diamond chain?
No. Moissanite is a different stone, and selling it as diamond is misleading and can be fraud. Say “moissanite” in the listing and the caption. See the legal page on fake luxury props for the details.
Is a moissanite chain worth more than a cubic zirconia one for video?
It costs a multiple of a cubic zirconia chain, and the extra buys hardness and fire, not a different look at arm’s length. For one skit, cubic zirconia is enough; for a series or close-ups, moissanite holds up better.

Keep reading